OzVMX Forum
Marque Remarks => Yamaha => Topic started by: Woody on February 24, 2011, 09:23:25 pm
-
I'm slowly putting my YZ125G back together. I thought that I had a good handle on what goes where and took a few pics when I dismantled her, but I can't find out where the seal in the right of these pics goes. It was amongst my box of swingarm pivot and rear axle bits & pieces. The thin washer on the left goes inside the left hand side swingarm thrust cover and interestling enough the right one doen't have one.
i can't seem to find this seal in the parts book.
(http://i380.photobucket.com/albums/oo249/vmxwoody/DSC04472cc.jpg)
(http://i380.photobucket.com/albums/oo249/vmxwoody/DSC04473cc.jpg)
-
Main seal ;). Split the cases and have a look :-[.
(How the hell would I know ::). Put the famous pen in the shot and we might have a wild guess 8)).
-
steering head seal??
-
Hard plastic or normal rubber?
-
Woody ol mate...Go to yamatopdog.com and click on yamaha online catalogue ( in red near the top centre ) and punch in Step 1 ..Motorcycle... Step 2... 1980 ...Step 3 ...YZ 125 G
If you think it`s swing arm click swing arm on the left hand menu and zoom in to look for it...part numbers are underneath...if its steering go to steering
Good Luck
-
That seal looks like the one that goes on the rear axle spacer on the left side of the wheel (covers the bearing etc)
3R3-25367-00-00 COVER, HUB DUST
-
thanks guys it's a plastic seal with a OD of approx 35mm and inner of 25mm.
I think that Cyclegod is on the money, I'll check the wheel over the weekend.
cheers
-
That seal looks like the one that goes on the rear axle spacer on the left side of the wheel (covers the bearing etc)
3R3-25367-00-00 COVER, HUB DUST
And the winner is - 'Cyclegod'
thanks guys, it gets very hard to tell the shape of some seals & collars etc from the parts book.
cheers