OzVMX Forum

Clubroom => Bike Talk => Topic started by: shorelinemc on February 15, 2011, 06:45:36 pm

Title: carb specs
Post by: shorelinemc on February 15, 2011, 06:45:36 pm

any one with a tt500 with a 38mm mikuni what jetting,needle etc are you running want to check what hatricks have given me

Title: Re: carb specs
Post by: curly001 on February 17, 2011, 10:15:03 am

I,m running a 36mm mikuni and these are my specs. Was dyno'ed by Carl Batey of Caferacer.com.au did story on 500 motor for VMX mag.

Slide 2.5
Jet(needle) P2(188)
Needle P2(188) clip on bottom slot with an additional shim
Pilot 35
Main 230

There are same rough spec's on 38mm on the SR500 forum also

Curly