OzVMX Forum
Marque Remarks => Yamaha => Topic started by: caps 999 on August 05, 2007, 06:07:00 pm
-
gday all im looking to start a dt1 mxer project i have a motor bassani pipe rolling frame and a tank im after a few bit for it like a carb seat and forks (dt, mx or yz) as long as they fit and keep the bike in pre75 i am also after a set of mudcatcher rims for the project if any one has any hint or tips for me it would be awsome ;D
-
am also after a set of mudcatcher rims ....
.... if any one has any hint or tips for me it would be awsome ;D
Yeah, don't use mudcatchers; too rare, too expensive.
-
The frame mod is supposed to be a winner - basically you add 50mm into the frame, in the down tube and between the downtube and swingarm pivot.
A smart man would have held onto a spare frame to make the mod easier to his own RT1 race bike project... apparently I'm not a smart man...
Both the people I spoke to who have done it, gave it the big thumbs up (Firko and a bloke at the Nats).
Nifty has been racing one to good effect as a pre-70 bike (got third in the pre-70 250s at the Nationals and was easily the best place trail bike in the class). He's not a big forum poster but hopefully he'll pip up in this thread.
-
Nathan I scored a DT1 frame from you a while ago its a bit rough but you can have it back if you like.
-
is it a square swing arm dt1
-
No Caps its not the pre70 swingarm but if someone out there has one to barter with I'm keen.
-
Heres a rim for you...
http://cgi.ebay.com.au/ws/eBayISAPI.dll?ViewItem&rd=1&item=140146065683&ssPageName=STRK:MEWA:IT&ih=004