OzVMX Forum

Marketplace => Wanted => Topic started by: Nathan S on January 20, 2008, 09:57:16 pm

Title: Cross brace for alloy bars.
Post by: Nathan S on January 20, 2008, 09:57:16 pm

Well, I actually need the clamps that hold the cross-brace to the bars, in the standard 22.2mm (7/8") diameter.

Hopefully someone's got a set of bent alloy bars, or something?

0400023847

Title: Re: Cross brace for alloy bars.
Post by: LWC82PE on January 21, 2008, 08:51:36 am

i will have a look today or tomorrow. i kn ow i had some, but not sure where they are or if i got them still

Title: Re: Cross brace for alloy bars.
Post by: TM BILL on January 21, 2008, 11:09:08 am

Give me your address Nathan i will put them in the post Bill  :)

Title: Re: Cross brace for alloy bars.
Post by: LWC82PE on January 21, 2008, 12:04:05 pm

no good here, i only got stipped ones

Title: Re: Cross brace for alloy bars.
Post by: gorby on January 21, 2008, 10:43:42 pm

found any yet,nathan?
should have some if you still need them

Title: Re: Cross brace for alloy bars.
Post by: paul on January 22, 2008, 11:55:52 am

this any  good to you
(http://i54.photobucket.com/albums/g120/ibop/IMGP1548.jpg)

Title: Re: Cross brace for alloy bars.
Post by: Nathan S on January 23, 2008, 09:22:58 am

Sorry for the slow reply gents...  :-[

The short answer is 'yes please' - I actually need a couple of sets, and a third pair wouldn't go astray.


I'll send some PMs. :)

Title: Re: Cross brace for alloy bars.
Post by: paul on January 23, 2008, 09:31:51 am

nathan send me your address  and i will wack it in the post