OzVMX Forum

Marque Remarks => Honda => Topic started by: oldyzman on October 26, 2010, 08:26:37 pm

Title: Flat slide Ei 38 carby on CR250 1983
Post by: oldyzman on October 26, 2010, 08:26:37 pm
Can someone advise what carby is std on this bike. and what the specs are for it hast anEi on it...Brett
Title: Re: Flat slide Ei 38 carby on CR250 1983
Post by: JohnnyO on October 26, 2010, 08:32:14 pm
The standard carby was a 36mm roundslide Keihin, probably better than the EI
Title: Re: Flat slide Ei 38 carby on CR250 1983
Post by: oldyzman on October 26, 2010, 09:10:02 pm
Thanks for the advice Johnny, i started the bike after i cleaned it out it sounded quite good. That Ei has no pilot jet all rather simple. I have a mikuni sitting there of a yz250 - wonder how that would go on the CR as i have plenty of jets etc to set it up...
Cheers Brett
Title: Re: Flat slide Ei 38 carby on CR250 1983
Post by: JohnnyO on October 26, 2010, 09:38:24 pm
The mikuni would be ok if it's in good condition. To jet the EI you wind the needle up or down or use a different taper needle, very basic.