OzVMX Forum

Marketplace => For Sale => Topic started by: elsie 125 on October 13, 2010, 06:02:37 am

Title: cr250m 1976
Post by: elsie 125 on October 13, 2010, 06:02:37 am

 hi guys, just got a 76 cr250m, to do up to race dirt track, would like 2 buy an exhaust pipe, muffler, cables, seat brackets, wonder if a down swept pipe would fit?? thanks for your help

Title: Re: cr250m 1976
Post by: jimg1au on October 13, 2010, 06:41:42 am

elsie
matcho mick has a nos barrell for this bike for salei think he wants $350.00
i have a vindro conversion as well mr250 motor pipe and spare barrell $500.00
thanks
jim

Title: Re: cr250m 1976
Post by: bigk on October 13, 2010, 08:53:32 am

I have a complete seat, some good engine parts, pretty mashed up tank and some other parts, no pipe though. I imagine a down pipe wouldn't be too hard to fit.
Cheers,
K

Title: Re: cr250m 1976
Post by: oldyzman on October 13, 2010, 09:20:54 pm

Hey Elsie,
I had one of those before, I was told that you can get an aftermarket down pipe prom the 74 model, you cut the pipe approx 6 inches from the flange spin it a bit and re weld it.As the 74 model comes out toward the other side compared to the 76 or just get a pipe made by GMC. I have a barrel on std bore for one of these available - jus needs a hone
Cheers Brett

Title: Re: cr250m 1976
Post by: jimg1au on October 13, 2010, 09:22:54 pm

brett&elsie
1975 1976 use the same pipe 1973 1974 are on the other side and down
jim

Title: Re: cr250m 1976
Post by: oldyzman on October 13, 2010, 09:26:05 pm

OK jim i will ammend, did the 75 hav an through frame pipe????

Title: Re: cr250m 1976
Post by: jimg1au on October 13, 2010, 09:29:56 pm

yes they did 73-74 same 75-76 same config

Title: Re: cr250m 1976
Post by: elsie 125 on October 13, 2010, 11:39:26 pm

thanks for your help guys, will send you all out a  pm, have just taken top end off, now too attack bottom end, which needs new rod, gaskets, bearings and seals,

Title: Re: cr250m 1976
Post by: oldyzman on October 15, 2010, 04:07:18 pm

Hey elsie r u in sydney?

Title: Re: cr250m 1976
Post by: jimg1au on October 15, 2010, 04:18:58 pm

brett
he is in the act and a good dirt tracker as well on his 125s

Title: Re: cr250m 1976
Post by: elsie 125 on October 15, 2010, 07:48:57 pm

jim, thanks so much for your help, I brought a couple of those big end bearings from the link you sent me

Yes am in canberra oldyzman

Title: Re: cr250m 1976
Post by: oldyzman on October 15, 2010, 09:04:51 pm

Hey Elsie,
if you were in sydney i was going to mention a couple of guys who have worked on cr's for many years...
Cheers