OzVMX Forum

Marque Remarks => Honda => Topic started by: smed on September 25, 2010, 06:33:40 pm

Title: CR250m PVL IGN
Post by: smed on September 25, 2010, 06:33:40 pm

I am thinking of  buying a PVL ign for my CR250m,For & against?all opinions gratefully accepted thanks Smed

Title: Re: CR250m PVL IGN
Post by: Rossvickicampbell on September 25, 2010, 06:54:02 pm

Smed - I had a PVL on my CR250 - extrememly reliable.  A number of times the guys with just points had the usual points problems.  I would recommend it.  Also if you go down that route check out these guys - www.rexcauntracing.com - in the UK so maybe don't have a price advantage now but they also carry parts which others don't do.

best of luck

Rossco

Title: Re: CR250m PVL IGN
Post by: smed on September 26, 2010, 05:36:29 pm

Thanks for the info rossco, muchas gracias!

Title: Re: CR250m PVL IGN
Post by: LWC82PE on September 26, 2010, 05:43:20 pm

http://www.roadandraceignitions.co.uk/17.html
might be useful

Title: Re: CR250m PVL IGN
Post by: smed on September 27, 2010, 08:56:58 pm

Thank,s for that link cheers

Title: Re: CR250m PVL IGN
Post by: TeeBone on September 28, 2010, 01:02:10 pm

Why not run a CR125 ignition? I have one on mine and it was cheaper than a PVL .

Title: Re: CR250m PVL IGN
Post by: smed on September 28, 2010, 06:32:31 pm

Tell me more tee bone,I dont ride my 125m anymore so i could take it off and use it on the 250!does it fit straight on or are mods needed? & how does it perform as the standard 250 has no advance mechanism where the 125 has electronic advance,I have noted the pvl has no advance either. :)

Title: Re: CR250m PVL IGN
Post by: TeeBone on October 04, 2010, 04:03:00 pm

The 125 ignition fits straight on - same taper on the crank - and it makes it way easier to start. You'll need to make brackets for the coil and CDI unit, but other than that it's a good conversion, giving a much better spark.
Do it, smed - you have nothing to lose!

Title: Re: CR250m PVL IGN
Post by: smed on October 04, 2010, 06:36:37 pm

O.K. man, cheers for the info! :)

Title: Re: CR250m PVL IGN
Post by: TeeBone on October 04, 2010, 07:07:41 pm

I was going to try and adapt a YZ80 ignition, but after talking with BigK, went the Honda route - I'm glad I did as there was less stuffing about with differing tapers etc. Thanks BigK!