OzVMX Forum
Marketplace => Wanted => Topic started by: Woody on July 27, 2010, 10:40:34 pm
-
Guys
Still looking for a good YZ125G (3R3) clutch basket (62 teeth on drive)
looks like YZ100 J and k may be the same
and any other good 125G spares you may have to offload.
cheers
Woody
1983 CR250RD parts / parts bike also wanted any condition considered
-
i might have one, i know there is a few bottom ends down there either 3R1 0r 3R3 or 1R8 - i have at least one of those numbers im sure right :D , will check next time im down the farm,
-
that'd be great freaky. from what I can tell this clutch basket only ran across those three particular models.
cheers
-
Does any one know if it 175 g is the same have one of those .
-
thanks but from what I can see they have a different part no. and no. of teeth
-
OK the one i have is in a 1R8, but has stamped 1m1 on the clutch cover plate itself, with cut outs on the hub finger and angled mesh mesh ring.
if i had a camera i would have taken a photo, also stood on my fone and it filled with water, amoung other disarters on the weeknd so i have nothing to show you :'(
-
thanks for looking Freaky, sounds like you had an interesting weekend.
the basket for the 125G is stamped 1W1 (like alot of others) byt has 62 teeth. I think the boss might be stamped 1G8. I can try and post a pic of one later on.
-
So what are you asking me ? to count the teeth on the primary ring ?
-
that's a lot of teeth to count. :D if it's not stamped 1W1 then it's probably not the right one. here's a pic
(http://i380.photobucket.com/albums/oo249/vmxwoody/DSCF0708.jpg)
(http://i380.photobucket.com/albums/oo249/vmxwoody/DSCF0710.jpg)
-
Where excatly is it stamped 1w1 ?