OzVMX Forum

Clubroom => Tech Talk => Topic started by: matcho mick on July 06, 2010, 06:57:39 pm

Title: 72 alpina,or sherpa rear wheel offset
Post by: matcho mick on July 06, 2010, 06:57:39 pm
can anyone tell me rear wheel offset,run ruler from brake drum to rim edge for me,(or to centre if tyres off)tia!,cheers mick
Title: Re: 72 alpina,or sherpa rear wheel offset
Post by: matcho mick on July 08, 2010, 11:28:00 am
ended up doing 70mm to centre,(now you's can all tell me it's wrong ::)),
Title: Re: 72 alpina,or sherpa rear wheel offset
Post by: huskibul on July 08, 2010, 11:59:29 am
   Mick, my crusty/trusty 72' sherpa run's at 68-70mm from brake backing plate/swingarm surface to rim edge (outside bead) if that make's any sense, :D cheers
Title: Re: 72 alpina,or sherpa rear wheel offset
Post by: matcho mick on July 08, 2010, 12:11:43 pm
shite,now you tell me ::),i only had bare wheel to do!,Huskibul ,whats measurement from brake drum edge to rim edge?,
Title: Re: 72 alpina,or sherpa rear wheel offset
Post by: huskibul on July 08, 2010, 01:07:26 pm
 Mick when you say "brake drum edge"do you mean drum-hub/sprocket surface?
Title: Re: 72 alpina,or sherpa rear wheel offset
Post by: matcho mick on July 08, 2010, 02:35:06 pm
yes mate,the wheel i'm doing is bare hub,no sprocket,or backing plate etc,go from your sprocket's inside edge to rim?,ta mick
Title: Re: 72 alpina,or sherpa rear wheel offset
Post by: huskibul on July 08, 2010, 02:39:25 pm
       43mm hope it helps
Title: Re: 72 alpina,or sherpa rear wheel offset
Post by: matcho mick on July 08, 2010, 02:51:33 pm
beauty Huskibul,i got 42,(43 on the bumps ;D),thanks for that,cheers mick