OzVMX Forum
Marque Remarks => KTM => Topic started by: ba-02-xr on May 31, 2010, 04:04:26 pm
-
Looking for the bump stop rubbers parte # 564.01.048.000. This is KTMs # not sure if it can be crossed to a White Power #.
-
NLA & if they were the would cost the better part of $100 for the pair. I had 2 x sets on BO for ages under both the KTM part and the WP part no. In the end I used a top out rubber from a later model Kawasaki fork. Not sure what part no or from what bike as they were left over bits from something. I have also been told that you can use the bump stop from an old school Ohlins piggy back, never went that route so not 100% sure.
-
Had a bit of a look , found a few if still needed.
Yes How much. PM me a # to call you on & I will ring you ;D
-
Thank you so much for your help Wasp. All bits I need.
-
Do the 4054 come std on the ktm? and what year if so... just a bit curious as i have some wp4054 on an old yammy...
oldyzman
-
84 495, 85 & 86 KTM, ATK. The screw in cap at the top should have a year & type of set up eg MX stamped to it.
-
Thanks for the info BA
-
Hi Guys,can anyone tell me where I can get a set of bushes (fork) for some 40mm WPs? numbers stamped in the top are 58.23 & F61
Any help would be good,
Whitey
-
Try Forum Member on here "Wasp" www.suspensionshop.org
for assistance
-
Thanks 4 that