OzVMX Forum

Marketplace => Wanted => Topic started by: juzze on February 19, 2010, 05:40:49 pm

Title: yz 125f crank
Post by: juzze on February 19, 2010, 05:40:49 pm

Hi just wondering if any one has a yz125 f crank they would like to sell i just pulled my motor apart and noticed some bodgy prick welded the big end pin up.

Title: Re: yz 125f crank
Post by: TT5 Matt on February 19, 2010, 09:13:18 pm

pm sent

Title: Re: yz 125f crank
Post by: Viper666 on February 22, 2010, 10:29:26 am

Depending on the weld job, doesn't mean it's dodgey. Some crank builders did this as par for course.
Also after a few rod replacement they do get looser so they are often welded.

Title: Re: yz 125f crank
Post by: juzze on February 22, 2010, 09:19:14 pm

Its just very anoying when u go to change the big end and you see it welded up your deffinently wright  its not bodgey i chose a bad way to explain it after seeing it.

Title: Re: yz 125f crank
Post by: Dirtbike BrainwashedMike on February 26, 2010, 05:07:26 am

Hi, I have yz125 D crank marked 1wi on the rod. Not sure if it's the same as the F. It will need rod kit. I'm on the NSW Central Coast if you want a look. If it's any good to you, make an offer.

Title: Re: yz 125f crank
Post by: juzze on February 28, 2010, 09:29:06 pm

Hi ill try find out if it is the same as mine thanks heaps.

Title: Re: yz 125f crank
Post by: Viper666 on March 02, 2010, 05:39:10 pm

They're different on the rotor side. 77 has fat tapper like for a flywheel, 79 onwards have the skinny tapper.
Viper666

Title: Re: yz 125f crank
Post by: juzze on March 07, 2010, 07:53:34 pm

Thanks heaps viper