OzVMX Forum

Clubroom => Tech Talk => Topic started by: Husk72 on January 27, 2010, 02:41:14 pm

Title: DT250-360 frames
Post by: Husk72 on January 27, 2010, 02:41:14 pm

Guys,I've been told that the 1974 DT250 and 360 frames were the same size..I have both and can't see any difference between them.
Is this correct?



                                                   Cheers,Mark.

Title: Re: DT250-360 frames
Post by: vandy010 on January 27, 2010, 02:44:53 pm

basically everything swaps over between the two frames.
so the frame number would be the only difference i'm aware of.
cheers.

Title: Re: DT250-360 frames
Post by: jimg1au on January 27, 2010, 03:22:17 pm

vandy is right
they also have the same specs as the mx250/360 frame swing arm is longer
cheers
ps
whant a 360 motor to go in one mx or dt

Title: Re: DT250-360 frames
Post by: Husk72 on January 30, 2010, 03:42:12 pm

Thanks for that Vandy and Jim.
I have a complete 360 with bad rust issues in the frame under the engine area.I also have a butchered frame that was used in a go-cart that is a 250,and it has the piece I need to replace rusted bit on the 360.
Whew,that solves the dilemma of finding and chopping up a perfectly good frame.


                                                Cheers,Mark.