OzVMX Forum

Clubroom => Vinduro => Topic started by: Twinshocker on November 02, 2009, 01:56:49 am

Title: Husqvarna CNC'd ignition cover
Post by: Twinshocker on November 02, 2009, 01:56:49 am

Here's a another little project I've worked on as well as the clutch covers.


As we all know the plastic ignition covers on our husky's distort with age and especially so when the screws are over tightened.

Anyway here's my effort at producing a cast and cnc'd ignition cover.

As allways, complements or constructive criticism are welcome.

Pics:

(http://i956.photobucket.com/albums/ae47/2518andy/P1000098.jpg)

(http://i956.photobucket.com/albums/ae47/2518andy/P1000103.jpg)

(http://i956.photobucket.com/albums/ae47/2518andy/P1000108.jpg)

(http://i956.photobucket.com/albums/ae47/2518andy/P1000111.jpg)

Cheers,

Twinshocker

Title: Re: Husqvarna CNC'd ignition cover
Post by: odd1 on November 02, 2009, 06:15:54 am

G.day
Look good did you make a sand cast ? Did you mill husqvana in ,or cast it and mill it later?

Title: Re: Husqvarna CNC'd ignition cover
Post by: Twinshocker on November 02, 2009, 10:13:22 am

Yeah the initial piece is sand cast and then cnc machined.

Husqvarna was milled in after the face was flatted and skimmed off.