OzVMX Forum

Marketplace => Wanted => Topic started by: Ji Gantor on October 27, 2009, 11:38:20 pm

Title: Ohlins Shock Tools
Post by: Ji Gantor on October 27, 2009, 11:38:20 pm

Ohlins shocks service tools.

Ji

Title: Re: Ohlins Shock Tools
Post by: Ji Gantor on October 28, 2009, 09:17:01 am

I would like to purchase all tools required to service piggy back gas/oil shocks.


Ji

Title: Re: Ohlins Shock Tools
Post by: Ji Gantor on October 28, 2009, 09:31:38 am

Where would one purchase said tools.

Ji

Title: Re: Ohlins Shock Tools
Post by: LWC82PE on October 28, 2009, 09:54:42 am

I have these 2 for sale. Brand new, never used. 2 pin tool fits TT44 shocks and MX USD front fork caps and 51mm reservoir clamping sleeve fits all twins and most singles. They are genuine Ohlins tools. They are pretty expensive, but very good. Its cheaper if you can make your own.

(http://4j2tea.blu.livefilestore.com/y1preZmD0wYRIH1pwG9LjW3CbTwPr3VZQErbPnA85mPBvS9_3XfpELeufG2Q1k2joMEC3LE9tDy6AcULsuiQcKEFA/tools.jpg)

Title: Re: Ohlins Shock Tools
Post by: Ji Gantor on October 28, 2009, 09:57:15 am

Hi  LWC82PE,
What does the two pin thingy do?
My shocks are 36mm diameter res.

Ji

Title: Re: Ohlins Shock Tools
Post by: LWC82PE on October 28, 2009, 10:02:03 am

The pin tool is only for later shocks/forks for undoing caps with 2 pins. The 51mm clamp is for the gold alloy reservoirs which measure 51mm OD with 44mm internal piston.

Title: Re: Ohlins Shock Tools
Post by: Ji Gantor on October 28, 2009, 10:11:15 am

Thanks LWC82PE,
So these two tools will not work on my shocks, Pitty.

Ji