OzVMX Forum

Marque Remarks => Suzuki => Topic started by: suzuki27 on October 18, 2009, 07:29:36 pm

Title: PE 250 T/X chamber
Post by: suzuki27 on October 18, 2009, 07:29:36 pm

I am after a PE 250 T/X pipe. I have a nice RM 250 T pipe or cash to trade or buy.

Title: Re: PE 250 T/X chamber
Post by: oldfart on October 19, 2009, 08:05:42 am

Pipe's are of  same design, Pe has a bit of mesh welded internaly.
What sort of coin are you asking for RM pipe 

Title: Re: PE 250 T/X chamber
Post by: suzuki27 on October 19, 2009, 06:04:27 pm

For the moment, I am wanting to swap.
The PE pipe I cut, 78 or 79 from memory, had 2 solid metal(tin) plates  spot welded in the fat part of the pipe- each with one smaller opening in the middle. About 2-3 fingers thick with the verniers.

Title: Re: PE 250 T/X chamber
Post by: lukeb1961 on October 19, 2009, 10:27:23 pm

that would have been the C pipe or perhaps an N.
The C definately had the restrictors to quieten things down.
If you have an early PE, this definately was a sound and performance killer.

The T and later did not have that, but did have a wire-mesh lining the chamber to stop the drumming / racket that the RM pipe would generate.