TM , RM 125 Down pipes

[TM BILL]

Dont want to hijack Petes thread but some questions were asked about pipes in the thread .

http://forum.ozvmx.com/index.php?topic=32151.0

The pipe Pete made for his bike is a work of art and a credit to him , and the best S pipe i have seen bar none 

Heres a selection of Down pipes for TM , TS, RM 125 M & S models

TM 125 original with pickle muffler , the owners handbook advises you will gain 2 HP if you run without the muffler 






TS 125 factory kit pipe , no muffler at all , indentations are to clear footpeg , brake pedal 





RM 125M pipe pressed steel construction and small permanently fitted muffler





RM 125S pipe cone construction with small permanently fitted muffler , this one has had a fitting put in the header for dyno tuning 









Aftermarket cone pipe with built in muffler , inside the pipe is a reverse cone that ends where the stinger tube starts .





Of all the pipes i have found the S pipe and the aftermarket pipe to give the best performance on TM and RM 125 S .

[TM BILL]

Pretty sure this is a TM 250 pipe  origin unknown

[Lozza]

Pipes with distinctive cones always work better than stamped or hydroformed sections. The S looks like it's has a tapered header as well.

[GMC]

GMC TM / RM chamber

[TM BILL]

GMC TM / RM chamber

Thats a nice pipe  i have a number of geoffs pipes on my bikes and bikes i have on sold . YZ 125A the GMC pipe for this bike has to be the best bolt on horsepower you can buy 

RM 250B  bolts straight on and delivers better power every where , i have since sold this one and have another on order 



RM 400N another straight bolt up job 





RM 125B bolts straight on and gives more over rev than the original 

[Ted]

WOW a steel arm painted aluminium. Is that legal

[TM BILL]

Ted i was able to provide evidence after much research that the paint was available in 1976 

[Ted]

OK, Clear to ride. Thru you go.

[Vintmxman]

How do I get in contact with the builder ? Need a bunch built..

[TM BILL]

https://www.google.co.nz/url?sa=t&rct=j&q=&esrc=s&source=web&cd=1&cad=rja&ved=0CCsQFjAA&url=http%3A%2F%2Fwww.geoffmorrisconcepts.com%2F&ei=WYaaUpa_GMjyiAfkyoC4CA&usg=AFQjCNGFxuWnmHcyDgEnEPCHrUEIiNV2_g&sig2=9OHaBWooLrYEn1hX9FruVQ

[Vintmxman]

Thanks TM Bill....