OzVMX Forum
Marque Remarks => Husqvarna => Topic started by: DJPresto on May 03, 2017, 07:23:38 PM
-
Can I replace the R/H crank seal behind the stator without splitting the cases? Cheers
-
if its in the little alloy holder held on by 4 screws...yes. $1 says the other side is screwed 8) check out HVA factory for a PDF manual free download.
-
Yes you can change the ignition side seal easily (without splitting the cases).
K
-
I have also changed the left side crank seal on a 390 motor before , without splitting the cases . The left main bearing was outside the seal , so I had to break out the cage of the bearing and then pull it out with a long , narrow 2 jawed puller in between the ball bearings . I then pulled the left crank seal out and replaced it with a new seal and new bearing .
-
impressive! 8)
-
Thanks for the responses :)